The Chrysler K-Car Club

I NEED TO REPLACE THE BUSHINGS ON THE WINDSHIELD WIPER LINKAGE ARMS/WIPER MOTOR ON MY '86 RELIANT.
DOES ANYONE KNOW THE BEST PLACE TO GET THESE BUSHINGS, AND A GOOD WAY TO INSTALL THEM???
I TRIED ONE OF THOSE "HELP" KITS FROM AN AUTO PARTS PLACE (THE KIT SPECIFIED 1974 AND UP CHRYSLER ON THE PACKAGE), BUT I COULD NOT FIGURE OUT WHICH BUSHING CONNECTED THE LINKAGE TO THE MOTOR!!

THANKS FOR THE HELP,

DDAYMEN

This is an easy fix. The easiest way to do this is to remover the entire wiper linkage assembly. Remove the pivots that the arms and blades attach to, the link between them and the link that goes to the motor also known as a bell crank. Also remove the nut that holds the mechanism to the motor shaft. Now, on the bench, look at the direction that the bushings go into the linkage pieces. Remove the old broken parts and install the new plastic parts in the same direction as the old ones. The best way to insert these is to use a socket as a receiver and place it on the link so that when you press the bush into it it will go into the socket after passing through the linkage. Use a channel lock pliers to push it into the linkage being sure to line the little guide tab up with the slot in the linkage. Now after you have all the bushings in place using the channel locks press the ball on the pivots into the cavity in the already installed bushing. Now, install the complete assembly into the cowl chamber. After working things into the chamber line up the pivot with the hole for installation. Be sure to line up the pin if you have one on your pivot with the hole made for it in the cowl. Now install the bellcrank onto the motor and operate without the wiper arms. Turn off the wiper motor and allow it to park. Lastly, install the wiper arms so that they sit on the windshield where you want them to. On most factory windshiels there is an arrow or dash on the glass where the wiper blade should sit. Good luck. Normally this takes a seasoned mechanic about 20 minut to do so something in the area of an hour would be expected for a non pro. Your local dealer should still stock these but I have used the Help Parts with good luck in the past. Help Parts are made by Dorman products.

can i get some help from anyone in here? i need some stuff online. my friend recommended these wiper blades from Wiper Wizard.. you think i should go for it? thanks.


_________________________________
1999 jeep grand Cherokee Limited
Eclipse CD7000
1995 Mazda Protege
Eclipse CD7100

The good thing about these,they are the same as for older Chryslers.So,the same parts that a Charger/Aspen/Monaco would use,the Ks use as well.That is the only reason they are still readily available.
So,there's a little bit of musclecar in every K....