Now after 2 weeks of intermittent stalling, and hard starting. I've done a complete tune-up, battery, coil, plugs, wires, cap and rotor.
It was throwing code 34 consistently, then after the tune-up started throwing code 37. Then a few days later started throwing both, and always kept stalling. I check over connections, pulled the big white plug next to the battery under the computer. All looked good, with no corrosion.
Now today it shut off and won't start at all, it just cranks and cranks, but won't start. The vehicle speed sensor and the torque converter lockup solenoid both had fluid inside the sockets where the plugs go, and i was going to replace them. At least the VSS anyway, it's the only one I can find in the aftermarket.
However, now it won't start at all. I pulled the coil wire at the distributor and put it against a bolt and there was no spark when cranking so I'm gonna get a plug and try it again to be sure.
Anything common in the electrical that goes out in these things?