Page 1 of 1

Digital dash problem

PostPosted: Tue Jul 26, 2016 4:27 pm
by Donny01TJ
I have a 88 Chrysler New Yorker with a digital dash and the back lights for the display went out. My grandmother was using the car for church and grocery shopping and with the infrequent use the battery went dead. She had a neighbor jump the car and I'm pretty sure he stuck the cables on the wrong way, ever since then - no dash. The information is still there: speed, fuel, odo, oil, temp, you just can't see it unless its really dark outside. The information center lights up and works just fine.

I'm somewhat descent with electronics and good with a soldering iron so I took a look at the boards. The capacitor at C12 was bad and the resistor at R66 was almost burnt in half. I got the capacitor replaced but I'm not sure what the value of the resistor should be.

I would also like to know what the pin-out is for the two dash connectors.

Any help is greatly appreciated!

Thanks,
-Donny

Re: Digital dash problem

PostPosted: Mon Mar 13, 2017 7:59 pm
by marty mopar
try this guy he may be able to rebuild it

507 313 3410

Donny

Dgood@hbci.com

Re: Digital dash problem

PostPosted: Wed Mar 15, 2017 12:02 am
by 89ARIES
I tried to make an appointment to see you this month in Arizona, and you never responded to my email. Maybe we can finally meet after 10 years in July.
I need parts.

Guy

Re: Digital dash problem

PostPosted: Tue Mar 28, 2017 9:52 pm
by marty mopar
will be here until about mid July